TRADEDOR TD77DM, Installation Manual

Page: 29 / 44

Tradedor TD77DM & TD77SEL Installation Guide
28
Clearing Memory Of Remote Control Handsets
(SAFETY EDGE)
Clearing Memory Of Base Rail Unit
(SAFETY EDGE)
1 Press and hold the “RADIO PROG” button (fig.10.3) .
You will hear a beep and the red LED alongside “C1”
will illuminate.
2 Insert screwdriver between the 2 pin terminals on
the board (MR) to bridge between them
(fig.10.3) .
3 Press and hold the “RADIO PROG” button (fig.10.3) .
The panel will beep 10 times and then go into 1
continuous beep. As soon as you hear this, release
“RADIO PROG” button and then remove screwdriver
from terminals and board will stop beeping.
4 Leave for several seconds and the receiver box will
beep twice to confirm end of programming.
To clear memory you will need a small screwdriver.
fig.10.3
MR
1 Press and hold the “PROG” button (fig.10.4A) on the
receiver card (this is the card plugged onto the board)
until you hear a single beep.
2 Insert screwdriver between the 2 terminals on the board
(forks below “PROG” button) to bridge between them
(fig.10.4B) .
3 Press and hold the “PROG” button, the panel will beep
8 times and then go into 1 continuous beep. As soon as
you hear this release “PROG” button and then remove
screwdriver from terminals and board will stop beeping.
4 Leave for several seconds and the receiver box will beep
twice to confirm end of programming.
To clear memory you will need a small screwdriver.
fig.10.4
B
A