TrackingTheWorld WorldTracker AVL, User Manual

Page: 9 / 94

The aerial/aerials may need to be adjusted for optimum signal strength. The
signal strength will be shown in HyperTerminal as:
Low
Medium or
High
Test 3 Test GPS module and GPS location
The following will appear on screen in HyperTerminal:
Testing GPS module
Non-valid GPS location
Press M to Return to MAIN MENU
Non-valid GPS location
Press M to Return to MAIN MENU
Non-valid GPS location
The GPS location will always be either:
Valid or
Non-valid
It may take several minutes for the GPS receiver to find the satellites and
return a valid location. Remember the GPS will only find a satellite if the
car is outside and the aerial has not been installed in a location in the
vehicle where the signal is blocked by metal.
Test 4 Test all the inputs
To read the Input Signals press 4 in HyperTerminal.
The unit will display current input signals as Activated or not activated.
Remember not all Input Signals can or will be connected up at this time.
This test will check the Input Signals to see if they are Activated or Not
Activated. You will need to activate the alarm for the input to be activated
(turn on with remote and open car door). You will need to activate GEO (PARK)
fencing / press the Panic Button for them to be activated.
** Please note: AUX input 3 neg is the analog input. Care must be taken to insure that the
input voltage on this pin is between 0 and +3.3Volt (Max). Any higher voltage may damage
the tracking unit or the onboard fuse on this input.
Pressing M will return you to the Diagnostic Main Menu when you are finished.
Test 5 Test all the outputs
To set or reset the Output Signals press 5 in HyperTerminal.
SET OR RESET OUTPUT SIGNALS MENU:
Press 1 to enable alarm
Press 2 to disable alarm
Press 3 to enable SOS
Press 4 to disable SOS
Press 5 to open car doors
Press 6 to flash GEO
(PARK) fencing LED
Press 7 to disable GEO (PARK) fencing LED
Press M to Return to MAIN MENU
Press 1 and the alarm will be enabled as shown in HyperTerminal:
- Alarm Enabled
You will then return to the Set or Reset Output Signals Menu.
Press
2 and the alarm will be disabled:
- Alarm Disabled
- 8 -