TrackingTheWorld WorldTracker AVL, User Manual

Page: 18 / 94

Delay time input voltage low or
high Setup delay time to trigger over or under voltage level
Speed limit Over the speed limit will send out message
Speed limit activation time Time of the speed keep over speed limit
Geo fencing activation When setup Geo fencing area, how to react on the geo
fencing
Geo fencing Area setup Rectangle geo fencing area setting
Real Time tracking interval
online For SMS only and GPRS only mode and AVL is activating.
(*1)
Real Time tracking interval
offline For SMS only and GPRS only mode and AVL is in sleep
mode.
(*1)
Working mode Switch between SMS only mode and SMS+GPRS mode
GPRS Mode: Select between UDP or TCP protocol
Static IP addr. Or Domain
name for GPRS: Enter static IP address or Domain name to receive GPRS
data
UDP destination port UDP port for GPRS data
TCP destination port TCP port for GPRS data
APN name Access point name for GPRS data
GPRS login name For setup GPRS connection
GPRS password For setup GPRS connection
Disconnect GPRS when
message is send If enabled will disconnect every time one message is sent
using GPRS
UDP OS update port Setup different port for firmware update via GPRS
Existing password To connect to unit via com port
New password To change the password
Check configuration is valid Check if the setting is valid (This check can only check
basic setup errors)
Select directory Select the directory of setting saved file
Select file Select the setting saved file to load
Load configuration
Save configuration
Save the settings into computer file
File selected The selected file will show in this window
Return to main menu Return to main menu
*1
Minimum Sending time (using GPRS) is about 10 seconds. It will be longer when using SMS for Real
time tracking. Sending time for SMS and GPRS depends on your GSM network speed to confirm and
process SMS and GPRS data commands.
*2
When resend messages is enabled the data compression option ‘Remove comma, points and other
exclamation from GPRS data’ cannot be enabled at the same time.
Please note that the tracking unit has 2 different GEO fencing modes.
For less confusion the ‘GEO’ fencing activated by GEO fencing input (or by SMS/GPS command
message - 21) will be called ‘PARK’ function.
1. The first PARK fencing mode is enabled when the ‘PARK fencing input’ is activated. In this case the
PARK fencing LED will flash to indicate that PARK fencing is activated.
This PARK fencing mode can also be enabled by SMS message. In this case the PARK fencing
activation can only be deactivated by SMS message.
2. The second option allows to configure a rectangle GEO fenced area. The unit can be configured to
respond when a vehicle enters or leaves the GEO fenced area.
- 17 -
Load the setting from computer file