TrackingTheWorld WorldTracker AVL, User Manual

Page: 23 / 94

Pulse counter Prescale AUX2 must be selected for Pulse Couonter. Select the
Prescale value for the counter.
Read I-Button ID Enable or disable I-Button detection
Panic Dial Out Number Select phone number to dial when Panic Input is
activated. When number is configured the AVL will dial
this number first to make a voice call. The voice call will
be disconnected if the Panic button is activated again (for
1 second or more) or caller hangs up the call (after the call
is connected). The AVL will only try 1 time to call out when
Panic button is activated. After voice call is disconnected
the AVL will send panic activation message. For no dial
out number leave the phone number blank.
SPECIAL FUNCTION SETUP
Send custom message to Base
phone number 2 This will send a custom message to Base 2 phone
number
Send Panic, Alarm, GEO or
Power loss activated to Base
Phone number 3 When enabled will also send ‘location message’ to Base
phone number3
Command received from
Base3 send back to Base1 All command messages are send to Base 1 only
Remove comman, points and
other exclamation from GPRS
data The ‘location message’ when using GPRS will be reduced
by about 25% to save data communication costs. When
resend messages is enabled the data compression option
‘Remove comma, points and other exclamation from
GPRS data’
cannot be enabled at the same time!
Send data using SMS if GPRS
fails This will send the data as SMS message if the GPRS
connection fails or is not available. As soon as GPRS is
available again the tracking unit will continue sending data
using GPRS
Enable commands from other
Base Phone numbers: Enable or Disable commands from other Base stations
Security ID code The unit will only process from other Base station that
have correct security ID code
Disconnect GPRS when in
sleep mode When the unit enters sleep mode the GPRS connection is
disconnected
Stop real time tracking when
roaming When the unit leaves its home network real time tracking
will stop
Sim card Code (4 Digits)
Enter pin code for SIM card (See *1)
Select GSM Band Select manual GSM Band. This will force the GSM
modem to only scan and use the selected GSM band.
Normally no need to select manual mode as the GSM
modem will auto scan all GSM bands.
Serial Port Data Select if serial port debug data or SMS text message is
send to the serial port
* Once the ADC input is activated (and message has been sent) the ADC delay time will
be reset back to zero disabling the ADC activation. To reactivate the value must be
reloaded using SMS command or using the configuration menu.
*1
- 22 -