MR5-WR542G
54Mbps Wireless Router User Guide
30
¾
Region
- Select your region from the pull-down list. This field specifies the region where the
wireless function of the router can be used. It may be illegal to use the wireless function of the
router in a region other than one of those specified in this field. If your country or region is not listed,
please contact your local government agency for assistance.
The default region is United States. When you select your local region from the pull-down list. Click
the
Save
button
,
then the Note Dialog appears. Click OK.
Note Dialog
Note
: Limited by local law regulations, version for North America does not have region selection
option.
¾
Channel -
This field determines which operating frequency will be used. It is not necessary to
change the wireless channel unless you notice interference problems with another nearby access
point.
¾
Mode -
Select the desired wireless mode. The options are:
•
54Mbps (802.11g) -
Both 802.11g and 802.11b wireless stations can connect to the router.
•
11Mbps (802.11b) -
Only 802.11b wireless stations can connect to the router.
Note
: The default is "54Mbps (802.11g)", which allows both 802.11g and 802.11b wireless stations
to connect to the router.
¾
Enable Wireless Router Radio -
The wireless radio of this Router can be enabled or disabled to
allow wireless stations access. If enabled, wireless stations will be able to access the router.
Otherwise, wireless stations will not be able to access.
¾
Enable SSID Broadcast -
If you select the
Enable SSID Broadcast
checkbox, the Wireless
Router SSID will broadcast its name (SSID) on the air.
¾
Enable Bridges
- If you select
Enable Bridges
, you can communicate with the other APs in bridge
mode by entering their MAC addresses. For example: If you want to communicate with the remote
AP whose MAC address is 00-E0-4C-00-07-BE, please enter the MAC address
00-E0-4C-00-07-BE in the
MAC of AP
field and configure the remote AP's bridge options.
¾
Enable Wireless Security
– The wireless security function can be enabled or disabled. If disabled,
the wireless stations will be able to connect the router without encryption. It is recommended
strongly that you choose this option to encrypt your wireless network. The encryption settings are
described below.
¾
Authentication Type -
You can select one of the following authentication types:
•
WEP -
Select WEP authentication type based on
802.11 authentications.
Summary of Contents for MR5-WR542G
Page 1: ...MR5 WR542G 54M Wireless Router Rev 1 0 0 2x to 3x eXtended Range 2 4GHz y 802 11g b...
Page 20: ...MR5 WR542G 54Mbps Wireless Router User Guide 15 Figure 4 1 Router Status...
Page 79: ...MR5 WR542G 54Mbps Wireless Router User Guide 74 Figure 4...
Page 80: ...MR5 WR542G 54Mbps Wireless Router User Guide 75 Appendix C Specifications...
