Page
11/68
STEP 18. Loosen half of the inside trim board LH by
unclipping the area shown to expose the grommet.
STEP 19. Locate the vehicle rubber grommet (
φ
13mm)
on the left hand side back of the vehicle. Remove the
vehicle rubber grommet and discard.
STEP 20. Cut and discard grommet B (the grommet
close to the inter-connector).
STEP 21. Pass through the camera inter-connector to the
vehicle grommet hole and install camera grommet to the
grommet hole as shown.
Just in front of the camera grommet, make U shape loop
on the rear camera wire, to prevent the water penetrating
into the vehicle.
CAUTION
-
Make sure that the rear camera wire loop is
facing down all the time.
-
Make sure that the camera wire loop is outside
the vehicle all the time.
