Page
64/68
Rear Camera Inner Wiring for vehicles with tray body
STEP 29. Locate the vehicle rubber grommet (
φ
13mm) on the left hand side back of the vehicle.
Remove the vehicle rubber grommet and discard.
STEP 30. Cut and discard grommet B (the grommet
close to the inter-connector).
STEP 31. Pass through the camera inter-connector
to the vehicle grommet hole and install camera
grommet to the grommet hole as shown.
Just in front of the camera grommet, make U shape
loop on the rear camera wire, to prevent the water
penetrating into the vehicle.
CAUTION
-
Make sure that the rear camera wire loop is
facing down all the time.
-
Make sure that the camera wire loop is
outside the vehicle all the time.
STEP 32. Pull the camera inter-connector from the
back seat area as shown.
