Page
49/68
Rear Camera Inner Wiring for vehicles with tub
STEP 18. Locate the vehicle rubber grommet (
φ
45mm) at the left hand side area underneath the
vehicle. Remove the vehicle rubber grommet and
discard.
STEP 19. Cut and discard grommet A (the 2
nd
grommet from the inter connector).
STEP 20. Install the camera grommet B (camera
grommet close to the camera inter-connector) to the
camera additional grommet (supplied) as shown.
NOTE:
Make sure that the lip of the smaller grommet is
seated firmly in the inner grove of the bigger
grommet.
STEP 21. Cut and take away the excess corrugated
tube before installing the camera grommet to the
vehicle.
NOTE:
Make sure that the camera wire at the outside of the
vehicle is covered with corrugated tube
