Page
26/68
STEP 15. Adjust the camera angle to number 11.5 of
the angle adjustment jig as shown. When the angle
is set, tighten the bolt of the camera.
IMPORTANT:
When fitting the camera bracket, torque the bolts to
1Nm.
STEP 16. Take the supplied protection tape and
then cut about 15mm wide of the tape as shown.
STEP 17. Apply the protection tape to the rear
camera wire until the corrugated tube as shown.
NOTE:
1) Make sure to wrap the camera wire start
from the wire on the camera side as shown.
2)
Make sure that all camera wire is wrapped
until the corrugated tube.
