Page
15/68
STEP 10. Remove the seat outer belt
’s floor anchor. And
then remove the centre pillar garnish lower LH as shown.
IMPORTANT:
When re-fitting the seat belts, torque the bolts to 42Nm.
STEP 11. Remove the front LH seat bracket cover as
shown.
STEP 12. Remove the 4 bolts from the front LH seat as
shown. Move the LH seat slightly to the front, so the
vehicle carpet is moveable.
IMPORTANT:
When re-fitting the seat, torque the bolts to 37Nm.
CAUTION:
There is a passenger seat sensor wire under the seat.
The wire does not need to be removed.
STEP 13. Set the rear camera for the bracket
installation. Check the back of the camera and see the
arrow mark and set the camera as shown.
