tousek
/ EN_PULL-TSA_03 / 25. 03. 2020
- 5 -
10
1
1a
3
5
5a
7
8
6
11
2
40
30
optionalhalf cylinder (PHZ)
with 3 keys (Art.code13300220)
4
4a
Technical layout PULL TSA
2. Installation
Sliding gate opener PULL TSA
General installation notes
Before installing the
Tousek PULL TSA
sliding gate operator we recommend checking the following points:
•
Checking the gate structure:
If the gate slides on floor rails, please check the bottom rollers and the upper guide rollers and make sure that
there is no undue friction or jamming. In caso of a cantilever gate please check if the gate can be moved out of
its end-positions without undue effort.
• The gate must travel in a stable manner without any lateral movements..
• Make sure that the gate travels in a regular way without undue friction or jamming along the whole travel length.
•
Make sure that there are stoppers at both ends of the track, preventing the gate from running over its travel limit.
ATTENTION !
• Attention: Mechanial limit stops are absolutely necessary!
• Attention: The sliding gate operator PULL TSA ias been developed and designed for the automation of hori-
zontally travelling sliding gates. Gates on sloping tracks (i.e. gates which follow an inclined, non-horizontal,
travel path) must not be automated without additional safety devices (which make sure that the gate cannot
start moving on its own from any gate position).
(1)
Lockable emergency release with optional
half-profile cylinder
(1a)
(2)
Gear wheel Z20
(3)
Cable fittings
(4)
Ground plate
(4a)
Slotted holes (4x) for mounting on the foundation
(5)
Control board with integrated receiver
(5a)
Motor cover
(6)
earthing screw
(7)
Sensor
(8)
Motor-/gear unit
(10)
Threaded hole to fasten the motor cover
(11)
