tousek
/ EN_PULL-TSA_03 / 25. 03. 2020
- 19 -
The handle in picture shows the unlocked position
In case of a power failure or other defect the motor can be
disengaged from the gearmotor as follows::
•
Switch off power supply
• Slide key-cover
(A)
slightly to the front and turn it away.
Insert the key and turn it clockwise to its limit stop (the
emergency release mechanism can be key-locked both
in the engaged and in the disengaged position).
• Turn the handle 180° counter-clockwise (viewed from
above). The gate can now be manually opened or closed.
Re-engaging the emergency release mechanism:
To return to normal motor operation please turn the handle
back to its original position (i.e. 180° clockwise)
Wichtig
•
after bringing the handle is back in normal position,
slowly move the gate manually in its travel direction,
until you can hear that the gearing has re-engaged!
Then lock again and remove the key.
With the next impulse the motor searches its open position
(do not need to programm the end positions again).
4. Emergency release in case of power failure
(note for the user)
PULL TSA
H
A
• Turn the cylinder protection cap down.
• Insert the key into the cylinder that has to be installed and
rotate the locking lug, so that the lock can be pushed into
the actuator.
• Remove the protective cap and secure the cilinder with
the screw (S). Then replace the protective cap.
• To re-insert the cylinder please carry out the above steps
in the reverse order.
S
5. Exchanging the halfprofle cylinder lock
Sliding gate operator PULL TSA
