
1. Insert the battery.
1
Remove the remote control
from the hanger.
Hanger
Remote control
2
Open the battery cover and
insert two AA batteries.
Open
Close
Battery cover
When you set the batteries correctly in
●
place, the following display lights up on the
rear side of the remote control.
3
Mount the remote control in
the hanger.
About the batteries
■
Use dry cell, alkaline batteries. Follow the
●
instructions below to prevent the batteries from
rupturing or leaking fl uid.
When replacing the batteries, use new batteries of
x
the same brand.
If you will not be using the remote control for a long
x
time, remove the batteries.
Do not use rechargeable batteries.
x
When the remote control is locked to
prevent theft
1
Remove the screws (2, left
and right) from the remote
control
¿
xture.
Wall
(Side view)
Loosen
Phillips screwdriver
(Fine-tip type)
Hanger
Fastening parts
(2, left and right)
Fastening parts (2, left and right)
Screw
(2, left and right)
Remote control
2
Remove the remote control
from the hanger.
Screw
(2, left and right)
Wall
Hanger
Remote control
Remove
To return
■
Tighten and fi x the screws (2, left and right).
(Overtightening may cause damage to parts
such as the hanger)
2. Turn on the power.
1
[North, Central, South America]
Insert the power plug.
The wand extends and then retracts.
x
[Asia, Oceania, Middle East]
Switch the breaker on the
distribution board to ON.
The wand extends and then retracts.
x
2
Check that the POWER LED
on the main display of the
Washlet is lit up.
If it does not light up, press [POWER ON/
x
OFF] to light it up.
3. Open the water supply valve.
1
Remove the side panel.
2
Fully open the water supply
valve.
<For water supply from floor>
<For water supply from wall>
3
Reinstall the side panel.
14
15
Introduction
Preparation
Using the Washlet for the First Time
Summary of Contents for NEOREST
Page 34: ...66 67 MEMO MEMO ...