Toto NEOREST, Instruction Manual, Page: 27 / 34

52 53
Reference
What to Do?
If there is no water due to a power outage or water failure
1 Use a bucket to
À
ush water.
Newspaper, dustcloth, etc.
Pour quickly, aiming
at the center of the
bowl unit.
Large bucket
2
If the water level is low after
À
ushing,
add more water.
Prevents odors.
x
Attention!
If there is a water supply failure, set the auto bowl unit
●
cleaning to "OFF".
If you cannot operate with the remote control
Operation is also possible using the
■
buttons on the Washlet control panel.
Washlet control
panel
If the Low Battery Warning LED is
À
ashing,
●
replace the batteries.
(Page 14)
Low Battery Warning LED
Replacing the batteries
■
1 Press [POWER ON/OFF] on the Washlet control panel.
The POWER LED goes off.
x
2
Remove the remote control from the hanger.
(Page 14)
POWER LED
3
Open the cover and replace the AA batteries.
(Page 14)
4
Mount the remote control in the hanger.
5
Press [POWER ON/OFF] on the Washlet control panel.
The POWER LED lights up.
x
Note
When the battery is replaced, the timer energy-saver, auto bowl unit fl ush, and other settings may be returned
●
to their default values.If this happens, please set them again.
Long Periods of Disuse
If you will be absent from home for a long time in the winter, be sure to drain the water to prevent
freezing.
Also, if the toilet is in a location you will not visit for a long time, drain the water.
(The water in the tank may become contaminated and cause skin infl ammation or other problems)
Before draining the water, check that the top unit is not lifted up and that the cleaning lift lever (Page 30) is retracted to its
●
original position.
How to drain the water
1
Close the water supply valve.
(Page 55)
2
Drain the pipe.
Remove the remote control from the hanger,
then press [WAND CLEANING] on the backside
of the remote control to extend the wand. Press
[WAND CLEANING] again to retract the wand.
(Page 17)
(For releasing the pressure from the water
supply pipe)
Remove the cover.
Cover
Remove the water fi lter drain valve.
Water filter drain
valve
Flat-head
screwdriver
After draining the water, mount the water fi lter
drain valve.
Tighten it securely using a fl at-head screwdriver.
x
Reinstall the cover.
3
Pull out the water drain lever.
The water comes out from near the wand for
x
about 20 seconds.
4
Release your hand to return the
water drain lever to its original
position.
5
Drain the water from inside the
toilet tank.
See the "Tank draining procedure" label on the
x
backside of the side panel (left).
6
[North, Central, South America]
Unplug the power plug.
[Asia, Oceania, Middle East]
Switch the breaker on the
distribution board to OFF.
7
Take appropriate measures for
the water remaining in the bowl
unit.
Putting antifreeze in the water remaining in the
x
bowl unit will reduce its chances of freezing.
To use the Washlet again
■
The water needs to be resupplied. (Page 54)
x