
8
9
Introduction
Safety Precautions
(Continued)
DANGER
To reduce the risk of electrocution:
1. Do not use while bathing.
2. Do not place or store the product where it can fall or be pulled into a tub or sink.
3. Do not place in or drop into water or other liquid.
4. Do not reach for the product when it has fallen into water. Unplug it immediately.
DANGER
To reduce the risk of burns, electrocution,
¿
re or injury to persons:
1. Close supervision is necessary when this product is used by, on, or near children or
invalids.
2. Use this product only for its intended use as described in this manual. Do not use
attachments not recommended by the manufacturer.
3. Never operate this product if it has a damaged cord or plug, is not working properly,
has been dropped or damaged, or has been dropped in water. Return the product to
a service center for examination and repair.
4. Keep the cord away from heated surfaces.
5. Never block the air openings on the product or place it on a soft surface, such as a
bed or couch, where the air openings may be blocked. Keep the air openings free of
lint, hair, and other similar items.
6. Never use while sleepy or drowsy.
7. Never drop or insert any object into any opening or hose.
8. Do not use outdoors. Do not operate where aerosol (spray) products are being used
or where oxygen is being administered.
9. Connect this product to a properly grounded outlet only.
See "Grounding Instructions" in Page 10.
10. The tank should be fi lled with water only.
CAUTION
If a water leak should occur, always close the water supply valve.
Preventing damage to pipes and hoses due to freezing
Frozen water pipes could cause the top unit and the pipes to break, resulting in a water leak.
x
Regulate the room temperature to prevent the pipes and hoses from freezing during cold months.
When installing the water fi lter drain valve, make sure that it is securely
tightened in its proper position.
Failure to securely tighten it might cause water leaks.
x
Always fl ush, even after just urinating.
Failure to do so could result in inadequate fl ushing and clog the bowl unit, causing waste water
x
overfl ow and water damage.
Wipe any urine, condensation, cleaner, water, etc. that has gotten on the
fl oor with a well-wrung mop or cloth.
Failure to do so could cause staining of the fl oor and corrosion.
x
[North, Central, South America]
When not using the Washlet over an extended period of time, drain the
water out of the top unit and the water supply hose, and pull the electrical
plug from the outlet.
When using the product again, allow the product to refi ll with water fi rst.
Otherwise, the water in the tank might become contaminated and cause skin infl ammation or
x
other problems.
Leaving the power ON might cause a fi re or heat.
x
If the bowl unit is clogged, disconnect the power plug and remove the
clog.
If the auto bowl unit fl ush were allowed to function, it would make the wastewater in the bowl
x
unit overfl ow resulting in water damage.
Use any commonly available toilet plunger to remove the clogging.
[Asia, Oceania, Middle East]
When not using the Washlet over an extended period of time, drain the
water out of the top unit and the water supply hose, and switch the
breaker on the distribution board to OFF.
When using the product again, allow the product to refi ll with water fi rst.
Otherwise, the water in the tank might become contaminated and cause skin infl ammation or
x
other problems.
Leaving the power ON might cause a fi re or heat.
x
If the bowl unit is clogged, switch the breaker on the distribution board to
OFF and remove the clog.
If the auto fl ush were allowed to function, it would make the wastewater in the bowl unit
x
overfl ow and may result in water damage.
Use any commonly available toilet plunger to remove the clogging.
Summary of Contents for NEOREST
Page 34: ...66 67 MEMO MEMO ...