
Do not use a dry cloth or
toilet paper on plastic parts.
(May cause damage)
Power plug
Top unit
Bowl unit
Except when using "Wand cleaning" or "Bowl unit cleaning".
*
[North, Central, South America]
*
After the power plug is inserted, the toilet lid will not open
automatically for about 10 to 60 seconds. (Because it is
preparing for operation) Open/close the toilet lid with the
remote control.
[Asia, Oceania, Middle East]
*
After the distribution board breaker is switched to ON,
the toilet lid will not open automatically for about 10 to 60
seconds. (Because it is preparing for operation) Open/close
the toilet with the remote control.
*
[North, Central, South America]
For safety, disconnect the power
plug before cleaning.
*
[Asia, Oceania, Middle East]
Switch the breaker on the
distribution board to OFF before
cleaning or maintenance.
28
29
Maintenance
Maintenance
Power plug
Power Plug
(Perform monthly)
<North, Central, South America>
Dry cloth
Wet cloth
1
Disconnect the power plug
and wipe it with a dry cloth.
2
Insert the power plug.
WARNING
Periodically remove dust from
●
the blades and other parts of the
power plug.
Disconnect the
x
plug and wipe
it with a dry
cloth.
Fully insert the power plug.
●
When disconnecting, hold the
●
main body of the power plug.
Pulling by the cord may damage
x
the plug or cord.
Top Unit
(Perform monthly)
Wet cloth
Toilet paper, etc.
(May cause damage)
1
[North, Central, South America]
Unplug the power plug.
[Asia, Oceania, Middle East]
Switch the breaker on
the distribution board to
OFF.
2
Wipe with a soft cloth
that has been soaked
in water and wrung-out
thoroughly.
For heavy dirt
■
Wipe with a soft cloth soaked in
x
diluted, neutral kitchen detergent.
Then, wipe with a soft cloth
soaked in water.
3
[North, Central, South America]
Insert the power plug.
[Asia, Oceania, Middle East]
Switch the breaker on
the distribution board to
ON.
Attention!
The Washlet is an electric appliance.
●
Be careful not to allow water to get
inside or leave detergent in the gap
between the top unit and the bowl
unit.
Do not push or pull the wand door or
●
the warm air dryer door with undue
force.
(May cause damage or
malfunctions)
2
Maintenance
Bowl Unit
(Perform daily)
Toilet brush
Toilet detergent
Strongly acidic cleaners or strong alkaline cleaners
Cleaners containing abrasive compounds
Wire brush
Abrasive nylon scrubbing brush
1
[North, Central, South America]
Unplug the power plug.
[Asia, Oceania, Middle East]
Switch the breaker on the distribution
board to OFF.
2
Clean with a toilet brush or a similar tool.
The bowl unit can be cleaned while the
■
toilet is
À
ushing.
(Insert the power plug or switch the breaker on the
distribution board to ON)
<Bowl unit cleaning>
Press [RINSE CYCLE] (backside of remote control, Page 17)
The toilet fl ushes (for about 30 seconds).
x
Clean inside the bowl unit.
x
The water in the bowl unit is drained and the water
x
level drops (for about 30 seconds).
The water in the bowl unit is drained and the water
x
returns to its original level.
To stop part way through, Press [STOP].
●
If the bowl unit is clogged
■
Use commercially available tools that are made for
x
unclogging toilets
Vinyl sheet,
etc.
If the
À
oor is dirty
■
Clean it with a well rung mop (not cleaning the fl oor may
x
stain the product or cause it to corrode)
The splashing of urine from standing urination can be
x
reduced by sitting down.
3
[North, Central, South America]
Insert the power plug.
[Asia, Oceania, Middle East]
Switch the breaker on the distribution
board to ON.
Attention!
Do not use any water repellant, stain-proofi ng cleaner or
●
surface coating agent.
These products would not damage the porcelain surface,
but they may cover the porcelain surface and reduce the
effect of the built-in stain prevention technology.
Top Unit/Bowl Unit
Summary of Contents for NEOREST
Page 34: ...66 67 MEMO MEMO ...