User’s Manual
83
Wireless information
Using this equipment in Japan
In Japan, the frequency bandwidth of 2,400MHz to 2,483.5MHz for second
generation low-power data communication systems such as this equipment
overlaps that of mobile object identification systems (premises radio station
and specified low-power radio station).
1. Important notice
The frequency bandwidth of this equipment may operate within the same
range as industrial devices, scientific devices, medical devices, microwave
ovens, licensed radio stations and non-licensed specified low-power radio
stations for mobile object identification systems (RFID) used in factory
production lines (Other Radio Stations).
1. Before using this equipment, ensure that it does not interfere with any of
the equipment listed above.
2. If this equipment causes RF interference to other radio stations,
promptly change the frequency being used, change the location of use,
or turn off the source of emissions.
3. Contact an authorized TOSHIBA service provider if you have problems
with interference caused by this product to Other Radio Stations.
2. Indication for Wireless LAN
The indication shown below appears on this equipment.
(1)
2.4
: This equipment uses a frequency of 2.4GHz.
(2)
DS
: This equipment uses DS-SS modulation.
(3)
OF
: This equipment uses OFDM modulation.
(4)
4
: The interference range of this equipment is less than
40m.
(5)
:This equipment uses a frequency bandwidth from
2,400MHz to 2,483.5MHz. It is possible to avoid the
band of mobile object identification systems.
Article 14
The low power radio-frequency devices shall not
influence aircraft security and interfere legal
communications;
If found, the user shall cease operating
immediately until no interference is achieved.
The said legal communications means radio
communications is operated in compliance with
the Telecommunications Act.
The low power radio-frequency devices must be
susceptible with the interference from legal
communications or ISM radio wave radiated
devices.
