Leveling the Mower Side-to-Side
1.
Position the
right
blade side-to-side (
).
g006888
Figure 97
1.
Measure here from blade
to hard surface
2.
Measure at B and C
2.
Measure the right blade at the
B
location, from a level
surface to the cutting edge of the blade tip (
).
3.
Record this measurement. This measurement needs to
be 80 to 83 mm (3-1/8 to 3-1/4 inches).
4.
Position the left blade side-to-side (
5.
Measure the left blade at the
C
location (
),
from a level surface to the cutting edge of the blade tip.
6.
Record this measurement. This measurement needs to
be 80 to 83 mm (3-1/8 to 3-1/4 inches).
7.
If the measurements at positions
B
or
C
are not
correct, loosen the bolt attaching the rear chain to the
rear-support arm (
g001040
Figure 98
1.
Rear chain
5.
Adjustment bolt
2.
Rear-support arm
6.
Front swivel
3.
Bolt
7.
Front-support arm
4.
Jam nut
8.
Loosen the jam nut under the rear-support arm and
adjust the adjustment bolt to get a measurement of 80
to 83 mm (3-1/8 to 3-1/4 inches); refer to
Note:
It is recommended that both sides of the
mower are adjusted the same distance.
9.
Tighten the jam nut under the rear-support arm and
tighten the bolt securing the chain to the rear-support
arm.
10.
Adjust the opposite side if needed.
Adjusting the Front-to-Rear Mower
Pitch
1.
Position the
right
blade front-to-rear (
).
g001041
Figure 99
1.
Measure here from blade
to hard surface
2.
Measure at A and B
66
Summary of Contents for Z593-D Z Master 74264TE
Page 75: ...Schematics g012068 g012068 Wire Diagram Rev A 75 ...
Page 76: ...Notes ...
Page 77: ...Notes ...
Page 78: ...Notes ...