Changing to Machine Operation
Rotate the bypass valves clockwise 1 turn to operate machine
(
).
Note:
Do not over-tighten the bypass valves.
Important:
The machine does not drive unless bypass
valves are turned in.
g010371
Figure 39
1.
Side console controls
3.
Hydraulic pumps
2.
Bypass valve
Transporting the Machine
Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary brakes,
lighting, and marking as required by law. Please carefully read
all the safety instructions. Knowing this information could
help you, your family, pets, or bystanders avoid injury.
To transport the machine:
•
Lock the brake and block the wheels.
•
Securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes.
•
Secure a trailer to the towing vehicle with safety chains.
WARNING
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow
moving vehicle emblem is dangerous and can
lead to accidents causing personal injury.
Do not drive machine on a public street or
roadway.
Loading the Machine
Use extreme caution when loading or unloading machines
onto a trailer or a truck. Use a full-width ramp that is wider
than the machine for this procedure. Back the machine up the
ramp and drive it forward down the ramp (
).
g028043
g028043
Figure 40
1.
Back the machine up the
ramp.
2.
Drive the machine forward
down the ramp.
Important:
Do not use narrow individual ramps for
each side of the machine.
WARNING
Loading a machine onto a trailer or truck increases
the possibility of tip-over and could cause serious
injury or death (
).
•
Use extreme caution when operating a machine
on a ramp.
•
Use only a full-width ramp; do not use individual
ramps for each side of the machine.
•
Do not exceed a 15-degree angle between the
ramp and the ground or between the ramp and
the trailer or truck.
•
Ensure that the length of ramp is at least 4 times
as long as the height of the trailer or truck bed
to the ground. This ensures that the ramp angle
does not exceed 15 degrees on flat ground.
•
Back up ramps and drive forward down ramps.
•
Avoid sudden acceleration or deceleration while
driving the machine on a ramp as this could
cause a loss of control or a tip-over situation.
32
Summary of Contents for Z593-D Z Master 74264TE
Page 75: ...Schematics g012068 g012068 Wire Diagram Rev A 75 ...
Page 76: ...Notes ...
Page 77: ...Notes ...
Page 78: ...Notes ...
