Toro Z593-D Z Master 74264TE, Operator'S Manual

Page: 18 / 80

Using the Rollover Protection
System (ROPS)
WARNING
To avoid injury or death from rollover: keep the
roll bar in the raised locked position and use the
seat belt.
Ensure that the rear part of the seat is secured with
the seat latch.
WARNING
There is no rollover protection when the roll bar is
in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance permits.
• Check carefully for overhead clearances (i.e.,
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
Important:
Lower the roll bar only when absolutely
necessary.
1. Remove the hairpin cotters and remove the 2 pins
(
Figure 10 ).
2. Lower the roll bar to the down position ( Figure 9 ).
Note:
There are 2 down positions; refer to Figure 9 .
3. Install the 2 pins and secure them with the hairpin
cotters (
Figure 10 ).
g004954
Figure 9
1. Full-down position 2. Down position with the
bagger installed
Important:
Ensure that you secure the rear part
of the seat with the seat latch.
4. To raise the roll bar, remove the hairpin cotters and
remove the 2 pins (
Figure 10 ).
5. Raise the roll bar to the upright position, install the 2
pins, and secure them with the hairpin cotters (
Figure
10 ).
Important:
Always use the seat belt with the roll
bar in the raised position.
G004955
1
2
3
4
g004955
Figure 10
1. Roll bar 3. Pin
2. Raised position 4. Hairpin cotter
Think Safety First
Please read all safety instructions and symbols in the safety
section. Knowing this information could help you or
bystanders avoid injury.
DANGER
Operating the machine on wet grass or steep slopes
can cause sliding and loss of control.
• Do not operate on slopes greater than 15 degrees.
• Reduce speed and use extreme caution on
slopes.
• Do not operate the machine near water.
18