Toro Multi Pro ExcelaRate 5800-G, Operator'S Manual

Page: 80 / 88

Installing the Agitation-Manifold
Valve
1. Align the flange of the agitation-bypass valve,
a gasket, and the end-cap-fitting flange of the
agitation-valve manifold (A of
Figure 106 ).
Note:
If needed, loosen the mounting hardware
for the pressure filter head as needed to provide
clearance.
g032551
Figure 106
1. Flange (pressure-filter
head) 5. Gasket
2. Flange (agitation-bypass
valve) 6. Quick connect
3. Flange (reducer coupling) 7. Manifold (agitation valve)
4. Flange clamp 8. Flange
(manifold—agitation
valve)
2. Assemble the agitation-bypass valve, gasket,
and agitation-valve manifold with a clamp
tightened hand tight (A of
Figure 106 ).
3. Secure the quick connect to the bypass fitting by
inserting a retainer into the socket of the bypass
fitting (A of
Figure 106 ).
4. Align a gasket between the flanges of the
pressure-filter head and the agitation-valve
manifold (B of
Figure 106 ).
5. Assemble the pressure-filter head, gasket, and
agitation-valve manifold with a clamp tightened
hand tight (B of
Figure 106 ).
6. Align a gasket between the flanges of the
agitation-valve manifold and the reducer
coupling (B of
Figure 106 ).
7. Assemble the agitation-valve manifold, gasket,
and reducer coupling with a clamp tightened
hand tight (B of
Figure 106 ).
8. If you loosened the mounting hardware for the
pressure-filter head, tighten the nut and bolt to
1978 to 2542 N∙cm (175 to 225 in-lb).
Installing the Section-Manifold
Valve
1. Insert the upper end-cap fitting of the manifold
valve into the bypass fitting (A of
Figure 107 ).
Note:
If needed, loosen the mounting hardware
for the bypass valve as needed to provide
clearance.
g032552
Figure 107
1. Flange (reducer coupling) 6. Socket (outlet fitting)
2. Socket (bypass fitting) 7. Retainer
3. Bypass valve 8. Flange (manifold—section
valve)
4. Flange (adjacent
manifold—agitation valve) 9. Gasket
5. End-cap fitting
(manifold-valve assembly) 10. Flange clamp
2. Secure the end-cap fitting to the bypass fitting
by inserting a retainer into the socket of the
bypass fitting (A of
Figure 107 ).
3. Assemble the outlet fitting onto the lower
end-cap fitting of the manifold valve (A of
Figure
107 ).
80