Toro Multi Pro ExcelaRate 5800-G, Operator'S Manual

Page: 60 / 88

Replacing the Fuel Filter
1. Remove the pickup tube of the fuel filter from
the fitting of the fuel pump (
Figure 74 ).
Note:
Discard the fuel filter.
g028351
Figure 74
1. Fitting (fuel pump) 4. Float arm (empty position)
2. Float arm (full position) 5. Fuel filter (short leg)
3. Pickup tube
6. Fuel filter (long leg)
2. Align the pickup tube of the new fuel filter with
the fitting of the fuel pump (
Figure 74 ).
3. Align the long leg of the fuel filter with float when
the float arm is in the empty position (
Figure 74 ).
4. Insert the fuel-pump fitting into the pickup tube
until the fitting is fully seated (
Figure 74 ).
Installing the Fuel Pump and
Sending Unit
1. Support the float arm and pickup tube together
and slip the float and fuel filter into the opening
in the fuel tank (
Figure 73 ).
Important:
Ensure that the float and the
long leg of the filter are pointing forward in
the tank and the fitting at the top of the fuel
pump points 90° toward the centerline of the
machine.
2. Seat the fuel pump/sending unit into the opening
in the tank (
Figure 73 and Figure 74 ).
3. Install the seal and nut over the fuel
pump/sending and onto the neck of the fuel tank
and tighten the nut hand tight (
Figure 73 ).
4. Connect the coupling on the fuel hose to the
fitting of the fuel pump (
Figure 73 ).
Note:
Ensure that the locking sleeve of the
fuel-hose coupling secures the coupling to the
pump fitting.
5. Connect the 2-socket connector of the
machine-wiring harness to the 2-pin connector
of the fuel pump/sending unit; Connect the 2-pin
connector of the machine-wiring harness to the
2-socket connector of the fuel pump/sending
unit (
Figure 73 ).
6. Rotate the starter switch to the O
N
position and
check the fuel-hose coupling for leaks.
Note:
If the coupling leaks, rotate the starter
switch to the O
FF
position, remove the key,
remove the coupling, check the coupling and
fitting for dirt or damage, and install the hose
and coupling onto the fitting.
Note:
Repair any fuel leaks before proceeding
to the next step.
7. Assemble the cover to the tank with the and 4
screws (#10 x 3/4 inch) that you removed in step
2 of Removing the Fuel Pump and Sending Unit
(page 58) .
8. Torque the screws to 113 N•cm (10 in-lbs).
60