Figure 20
1. PTO switch
Disengaging the PTO
To disengage, push the PTO switch to the off
position.
Adjusting the Height-of-Cut
The height-of-cut is adjusted from 1 to 6 inches
(2.5 to 15.8 cm) in 1/4 inch (6 mm) increments by
relocating the stop pin into different hole locations.
1. With the engine running, pull back on the deck
lift lever until the mower deck is fully raised and
release the lever immediately
(Figure 21).
2. To adjust, rotate the stop pin until the roll pin
in it lines up with the slots in the holes in the
height-of-cut bracket and remove it (Figure 21).
3. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired,
insert the pin, and rotate it down to lock it in
place (Figure 21).
Note:
There are four rows of hole positions
(Figure 21). The top row gives you the height
of cut listed above the pin. The second row
down gives you the height listed plus 1/4
inch (6 mm). The third row down gives you
the height listed plus 1/2 inch (12 mm). The
bottom row gives you the height listed plus
3/4 inch (18 mm). For the 6 inch (15.8 cm)
position there is only one hole, located in the
second row. This does not add 1/4 inch (6
mm) to the 6 inch (15.8 cm) position.
Figure 21
1. Deck lift lever
3. Height of cut stop
2. Stop pin
4. Adjust the anti-scalp rollers and skids as
required.
Adjusting the Skids
Mount the skids in the lower position when
operating in height of cuts higher than 2-1/2
inches (64 mm) and in the higher position when
operating in height of cuts lower than 2-1/2 inches
(64 mm).
Note:
On Guardian
®
mowers, when the skids
become worn, you can switch the skid to the
opposite sides of the mower, flipping them over.
This will allow you to use the skids longer before
replacing them.
1. Disengage the PTO, move the motion control
levers to the neutral locked position, and set
the parking brake.
2. Move the throttle lever to the Slow position,
stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
32
Summary of Contents for Groundsmaster 7200 Series
Page 9: ...Slope Chart 9 ...
Page 44: ...Figure 39 44 ...
Page 70: ...Schematics Electrical Schematic Rev A 70 ...
Page 71: ...Hydraulic Schematic Rev A 71 ...
