Avoid Cutting Too Low
If the cutting width of the mower is wider than the
mower you previously used, raise the cutting height
to ensure that uneven turf is not cut too short.
Long Grass
If the grass is ever allowed to grow slightly longer
than normal, or if it contains a high degree of
moisture, raise the cutting height higher than usual
and cut the grass at this setting. Then cut the grass
again using the lower, normal setting.
Keep the Underside of the Mower
Clean
Clean clippings and dirt from the underside of the
mower after each use. If grass and dirt build up
inside the mower, cutting quality will eventually
become unsatisfactory.
Blade Maintenance
Maintain a sharp blade throughout the cutting
season because a sharp blade cuts cleanly without
tearing or shredding the grass blades. Tearing
and shredding turns grass brown at the edges,
which slows growth and increases the chance of
disease. Check the blades daily for sharpness, and
for any wear or damage. Sharpen the blades as
necessary. If a blade is damaged or worn, replace
it immediately with a genuine Toro replacement
blade. Refer to Servicing the Cutting Blades in
Mower Deck Maintenance, page 62 for more
information or identifying blade problems and
sharpening the blades.
40
Summary of Contents for Groundsmaster 7200 Series
Page 9: ...Slope Chart 9 ...
Page 44: ...Figure 39 44 ...
Page 70: ...Schematics Electrical Schematic Rev A 70 ...
Page 71: ...Hydraulic Schematic Rev A 71 ...
