If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Figure 38
Service Interval Chart
Lubrication
Greasing the Bearings and
Bushings
The machine has grease fittings that must be
lubricated regularly with No. 2 General Purpose
Lithium Base Grease. If the machine is operated
under normal conditions, lubricate all bearings
and bushings after every 50 hours of operation.
Bearings and bushings must be lubricated daily
when operating conditions are extremely dusty and
dirty. Dusty and dirty operating conditions could
cause dirt to get into the bearings and bushings,
resulting in accelerated wear. Lubricate the grease
fittings immediately after every washing, regardless
of interval specified.
1. Wipe the grease fittings clean so foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the fittings.
3. Wipe off excess grease.
Figure 39 and Figure 40 illustrate the locations of
the grease fittings.
Important:
The fittings on the axles of the
caster wheels are not illustrated. Ensure that
you grease these fittings as well.
43
Summary of Contents for Groundsmaster 7200 Series
Page 9: ...Slope Chart 9 ...
Page 44: ...Figure 39 44 ...
Page 70: ...Schematics Electrical Schematic Rev A 70 ...
Page 71: ...Hydraulic Schematic Rev A 71 ...
