Toro 04510 Greensmaster 3300 TriFlex, Service Manual

Page: 27 / 332

Greensmaster 3300 Page 3 -- 9 Gasoline Engine
Removal (Fig. 3)
1. Park machine on a level surface, disengage and low-
er cutting units, move functional control lever to neutral
(N), engage parking brake, stop the engine and remove
the key from the ignition switch. Wait for all machine
movement to stop.
DANGER
Gasoline is flammable. Use caution when storing
or handling it. Do not smoke while filling the fuel
tank. Do not fill fuel tank while engine is running
or in an enclosed area. Always fill fuel tank out-
side and wipe up any spilled fuel before starting
the engine. Store fuel in a clean, safety--ap-
proved container and keep the cap in place. Use
gasoline for the engine only; not for any other
purpose.
2. Access the carbon cannister under the fuel tank and
between the rear frame sections. If necessary, raise and
support tank mount plate assembly (hydraulic reservoir,
fuel tank and tank mount plate) to reach the cannister
(see Tank Mount Plate Assembly in the Service and Re-
pairs section of Chapter 7 -- Chassis).
3. Inspect carbon cannister and attached for damage
or obvious leaks. A damaged or leaking cannister
should be replaced.
4. Remove components as needed using Figure 3 as
a guide.
A. If check valve (item 15) is removed, note direction
of arrow on valve body for assembly purposes.
Installation (Fig. 3)
1. Install all removed components using Figure 3 as a
guide.
A. If check valve (item 15) was removed, make sure
that arrow on valve body points toward engine.
B. Make sure that fuel hoses are not kinked after
installation. Also, secure all hoses with hose clamps.
2. If tank mount plate assembly (hydraulic reservoir,
fuel tank and tank mount plate) was raised to access the
cannister, lower and secure tank mount plate assembly
(see Tank Mount Plate Assembly in the Service and Re-
pairs section of Chapter 7 -- Chassis).
Figure 4
1. Carbon cannister
2. Hose to tank vent
3. Hose to engine
3
2
1
FRONT
Gasoline Engine