3.6
ASSEMBLY AND ADJUSTMENT OF FAST AND SLOW SLIDING WINGS
Fig.
17
Slow wing
Fast wing
Antiderailment wheel
SX
Bearing wheels
Trolley
screw
Adjustment screw
Trolley
DX
Fig.
18
Fig.
19
16
K200T-K280T
EN
INSTRUCTIONS FOR INSTALLATION AND USE
-Fasten the slow wing on the sliding base of the crossbar by tilting and inserting it while lifting it slightly upward, while
the fast wing is fastened straight (Fig.17);
To fasten the sliding wings to the crossbar proceed as follows:
@
If an air seal brush is foreseen between the fast wing, the slow wing and the upright or fixed wall, adjust the wing
so that there is a space of about 1 mm on the entire length between the brush and the wing;
Adjust the wing height using the special adjustment screws on the trolleys (Fig.18 and 21). After performing this
operation, tighten the screws on the load-bearing wheels and raise the antiderailment wheel;
-Bring the wings up to the crossbar and make sure the sliding base of the trolleys is clean and free of any scraps;
@
Make sure the slow wing is raised off the floor by at least 12 mm and the fast wing is raise of the floor by at least
5mm.
-Before tightening the screws make sure the trolleys are aligned with the crossbar and with each other;
@
Use the height adjustment screws on the trolleys to raise or lower the wing by ±10mm (with the crossbar correctly
installed in respect of the measurements and dimensions shown in Fig.8).
-Lower the antiderailment wheels of the trolleys (Fig. 18);
-Fasten the runner of the slow wing in accordance with measurement “A1” on the floor using the d.8 blocks and self-
tapping screws type d.5x60 found in the hardware package (fig. 22); then fasten the runner of the fast wing on the
front vertical upright of the slow wing, based on measurement “A2”, using the self-tapping screws type d.4.8x20 found
in the hardware package (Fig.23);
-Loosen the trolley fastening wheels and fit the no. 10 wrench supplied into the special adjustment screw to adjust the
height of the trolley. Turn it to the right or left so as to raise the wing off the flow by about 12 mm (measurement of the
standard runner);
-Adjust the space “A1” and “A2” (Fig.22 and 23) by loosening the screws that fasten the lower brackets of the trolley
to the adapter. There are slots on the base of the brackets that can be used to move the wing by about 18 mm;
-Decide distance “A1” and “A2” for adjustment of the wing (Fig. 20);