IT
3
3.1
3.2
11
K200T
-K280T
INSTALLATION
GENERAL RECOMMENDATIONS
The automation must be installed exclusively by competent, qualified technical personnel in possession of the
technical requisites foreseen by the legislation in force in the country of installation.
&
The glass for door panels shall comply with the provisions of the Standard (EN 16005 4.4.2 - Materials: tempered
glass in accordance with EN 12150_1; stratified glass in accordance with EN ISO 12543-1 and EN ISO 12543-2).
&
Do not use the automation in environments with a potentially explosive atmosphere.
&
The forces developed by the complete system during operation must respect the regulations in force in the country of
installation; if this is not possible, protect and signal by means of electronic safety devices the zones affected by those
forces.
&
During installation of the door, take care to avoid any risks during the movement of closure and/or opening the door,
and to protect against risks in accordance with the provisions of standard EN 16005 at item 4.6.2.1 for the door opening
movement and item 4.6.2.2 for door closure. Protection of the primary closing edge should take account of the types of
users of the door (see EN 16005, 4.6.2.2).
&
Before installing the automation, verify that the structure to be automated is stable, sturdy and able to withstand the
weight of the automation and, if necessary, take steps to ensure that it is. Topp srl is not liable for failure to comply with the
rules of good workmanship in the construction of the door panels to motorize, or for any distortions that may develop with
use of the device.
&
Do not install the automation on the external wall of the building, subject to atmospheric agents (rain, snow, etc.).
INSTALLING THE CROSSBAR
INSTRUCTIONS FOR INSTALLATION AND USE
EN
-Remove the automation casing cover.
-Fasten the crossbar to the wall, positioning 3 self-tapping screws type d.5.5 or d.6.3 for every meter of crossbar,
-Fasten the supporting brackets to the wall using self-perforating/self-tapping screws type d5.5 or 6.3.
@
If the floor is not perfectly flat, decide the position of the supporting brackets using the highest point of the floor
as your reference.
-Install the crossbar and check the alignment.
(Model with 4 wings)
Proceed as follows to assemble the crossbar:
-Mark the center of the opening VL on the wall or surface for fastening, corresponding to the center of the crossbar;
-Fasten the supporting brackets to the wall using self-perforating/self-tapping screws type d5.5 or 6.3.
-Remove the automation casing cover.
-Install the crossbar and check the alignment and horizontal leveling.
-Fasten the crossbar to the wall, positioning 3 self-tapping screws type d.5.5 or d.6.3 for every meter of crossbar,
taking care not to damage the sliding base of the trolleys with the drill chuck. In case of damage, it is necessary to
replace the entire crossbar.
(Model with 2 wings)
- Proceed as follows to assemble the crossbar:
-Mark the starting point of the crossbar on the wall or surface for fastening, corresponding to:
Ÿ
The right edge of the opening wall for application of 2 wings with the opening on the left;
-After fastening the crossbar, clean the sliding zone carefully to remove any drilling residues.
-Decide the position in which to fasten the supporting brackets of the crossbar, referring to the measurements shown
in Fig.8.
@
If the floor is not perfectly flat, decide the position of the supporting brackets using the highest point of the floor
as your reference.
Ÿ
The left edge of the opening wall for application of 2 wings with the opening on the right;
-Decide the position in which to fasten the supporting brackets of the crossbar, referring to the measurements shown
in Fig.8.
