Fig.
23
Slow wing plastic runner
WALL
Fig.
22
Fast wing plastic runner
Fast wing back part
Slow wing
LPF
12
5
Fast wing
SLO
W W
ING
FAS
T W
ING
Two self-drilling screws
3.7
ASSEMBLING DRIVE BRACKET AND BELT BLOCK BRACKET ON SLOW WING
18
K200T-K280T
EN
INSTRUCTIONS FOR INSTALLATION AND USE
Slow wing back part
-Align the front upright of the slow wing with the rear upright of the fast wing in the closed position, fasten the drive
bracket on the belt, then fasten it to the rear trolley of the fast wing (Fig.25 and 26).
Assemble the drive bracket and belt block bracket on slow wing as shown in the figures:
(Use the same assembly procedure for all models, 2-wing and 4-wing, but with different right and left brackets).
NOTE: Insert the threaded plate on the crossbar.
-Make sure the belt CAL of the slow wing is tightened correctly and the trolleys have been fastened and adjusted
permanently;
-Stack and align the slow wing with the fast wing in the open position, fasten the FCT bracket (crossbar belt block) on
the crossbar with the specific M5x12 screws (Fig. 27). It permits adjustment by ± 20mm.
