RACEWAY 20 MM
30
30
20
RACEWAY 30 MM
30
30
30
RACEWAY 50 MM
30
30
50
Slow wing
Slow wing
Fast wing
Fast wing
Fastening bracket for closing profile
Closing
profile
Closure raceway with relative fastening brackets
:
3.12
ASSEMBLING RACEWAY FASTENING BRACKETS FOR CLOSURE OF THE SLOW WING
Fig.
42
L
L/3
L/3
15
15
15
convex hexhead M5x10 screw
M6 Nuts
M6x10 screw
Casing in sheet metal for
profiles
up to 25 mm
Fig.
43
Trolleys for
profiles
up to
25mm
27
INSTRUCTIONS FOR INSTALLATION AND USE
- Fasten the two brackets provided to the profile of the crossbar using two M6x10 screws and two M6 nuts, which must have been
inserted previously in the housing provided on the crossbar, as shown in fig. 42. The positioning measurements of the two brackets
are shown in the figure;
For the bottom profiles at 45÷50 mm use two different covering casings, i.e. profiles up to 25 mm and profiles up to 35 mm with the
relative trolleys (Fig.43).
- Cut the raceway to size according to the formula: Raceway length =L - 20 mm (fig.42);
-Drill the raceway with a 6 mm bit at the holes on the fastening brackets and fasten the raceway to them using two convex hexhead
M5x10 screws.
It is possible to cover the zones in view between the slow wing (see wing closure) using raceways (20÷30÷50) with the relative
fastening brackets. Proceed as follows to install them:
M6 Nuts
M6x10 screw
convex hexhead M5x10 screw
M6 Nuts
M6x10 screw
convex hexhead M5x10 screw
Casing in sheet metal for
profiles
up to 35 mm
Trolleys for
profiles
up to
35mm
K200T
-K280T
EN
