Toho Electronics TRM-10C, Instruction Manual, Page: 13 / 129

―
12
―
HXPRM10mnCT002E
2.2.2 Operation Keys
The following describes each operation key.
This manual represents the actual operation keys as shown in the figure below.
Fig. 2.3 Operation Keys in This Manual
Table 2.1 Names of Operation Keys and Their Functions
Key Name Function
“
RUN
”
key
Starts/stops recording. To stop, hold down the “RUN” key for 3
seconds or more. (Gone out the “RUN” lamp.) To start, press
the “RUN” key. (Illuminates the “RUN” lamp.)
“
MENU
”
key
MENU
function Selects engineering list print and change to
the setting mode.
“
ESC
”
key
ESC
function Exits that menu halfway selecting a
function.
“
PRINT
”
key
PRINT
function
Used to perform manual print or list print.
“△”
key
△
function
Used to select a setting parameter
(numeral or built-in command)(ascending
direction).
“
FEED
”
key
FEED
function The chart paper is fed while the key is
pressed, and stopped when released.
key function Used to shift a digit in setting a numeral.
“
ENT
”
key
Used for registering a setting parameter (numeral or built-in
command) after selecting it, or executing a function. Pressing
this key executes the setting.
RUN
ENT
ESC
MENU
PRINT
FEED
RUN
ALM
CH. No. DATA
ESC
▲
▲
RUN
PRINT FEED
ENT
ESC
MENU
RUN MENU PRINT FEED ENT
H
L