TiVo Roamio OTA, Manual

Page: 78 / 119

65
Settings
5
Unpairing your remote (to use it with a different TiVo box)
To pair the remote with a different Roamio Pro, you must first unpair it with the current DVR,
then pair it with the new one. Note that this process will reset the remote completely, so
you will need to repeat setup of the remote’s programmable buttons (TV power, volume,
mute). To unpair the remote:
1. Hold down the POWER and TiVo buttons at the same time until the activity light
flashes.
2. Press THUMBS DOWN three times.
3. Press ENTER.
Remote control finder (Roamio Plus & Roamio Pro only)
Lose your remote? No problem. Just press the button on the front of the Roamio Plus
or Roamio Pro to use the remote finder. To turn off the remote finder, press this button
again, or press any button on the remote.
CableCARD
™
Decoder
This screen is typically used only during CableCARD installation. It is not applicable on the
TiVo Roamio OTA.
A CableCARD decoder receives encrypted digital cable programming and decodes it for
display on your TV without the need for a cable box. On the TiVo Roamio Plus/Roamio Pro,
the CableCARD decoder plugs into the CableCARD slot on the back of the DVR. On the
four-tuner TiVo Roamio, the CableCARD decoder plugs into a compartment on the
underside of the DVR.
A CableCARD decoder is available only from your cable company and additional fees may
apply from your cable company. It replaces your digital cable box, and allows you to receive
the same programming channels in your subscription. To watch and record digital cable