Titan 550xc, Owner'S Manual

Page: 17 / 24

© Titan Tool Inc. All rights reserved. 17
Motor Assembly
1
2
3
4
5
6
7
8
11
9
10
3
12
13
14
Item Part # Description Quantity
1 765-062 Screw ................................................4
2 765-032 Rear cover ........................................1
3 765-006 Snap ring ..........................................2
4 765-025 Coupling nut (torque to 25 in./lbs.) ...4
5 765-060 Lock washer......................................4
6 765-019 Mounting stud ...................................4
7 765-012 Wave washer ....................................1
8 765-020 Armature ...........................................1
9 765-099 Motor housing (includes item 10) .....1
10 765-059 Screw ................................................1
11 765-016 Motor field assy.................................1
12 765-008 Fan....................................................1
13 765-029 Motor housing cover .........................1
14 700-639 Screw ................................................4
Before proceeding, follow the “Pressure Relief Procedure”
in the Operation section of this manual. Additionally,
follow all other warnings to reduce the risk of an injection
injury, injury from moving parts or electric shock. Always
unplug the sprayer before servicing!
WARNING
Replacing the Armature
1. Remove rear cover (2) by taking out screws (1).
2. Remove snap ring (3).
3. Remove fan (12).
4. Remove snap ring (3).
5. Remove motor housing cover (13) by removing screws
(4).
6. Remove the motor brushes. Follow the “Replacing the
Motor Brushes” procedure in this section of the manual.
7. Remove the armature (8) by gently rocking and pulling the
fan from the rear of pump.
8. Inspect the armature. If damaged, replace.
9. To replace the armature, reverse steps 1–7 above.
Replacing the Motor Housing
1 Follow steps 1–6 of the “Replacing the Armature”
procedure above.
2. Remove the pressure control board and screws (see the
“Gear Box Assembly” parts list) .
3. Disconnect the black wire and the white wire that connect
the motor to the pressure control board (refer to the
electrical schematic in this section of the manual).
4. Remove motor housing (9).
5. Loosen set screw (10) and push motor field assembly (11)
out from the back of the motor housing.
6. Inspect the motor field assembly. If damaged, replace.
7. To install the motor housing, reverse steps 1–5 above and
steps 1–7 of the “Replacing the Armature” procedure.
NOTE: Make sure to remove wave washer (7), which
should be on the end bearing of the
armature.