Timewave DSP-D300, Manual

Page: 61 / 112

4. Open Ethernet connection (for Ethernet use).
a. Static IP address.
b. Gateway IP address
c. DNS Server IP addresses
d. Telnet/TCP server IP addresses for packets
e. Alarm server IP address
5. Administrator access to the Windows PC for NT based PCs (Win95 based
already have administrator access).
Connecting the Cables
Note: DO NOT CONNECT THE POWER AT THIS TIME!
Power Connector
RS-232 COM1 – Local Connection
RS-232 COM2 – Satellite Connection
Audio Data Input Connector
Audio Data Monitor connector
Ethernet connector
USB “B” connector
Figure 28: DSP-D300 Back Panel
1a. For systems with serial connections:
Connect the RS-232 cables between the DSP-D300 and the destination
Hardware.
1b. For systems with Ethernet connections:
Connect the Ethernet cable between the DSP-D300 and the hub. Make
sure that you do NOT connect the Ethernet cable to the Radio Audio Jack!
2. Connect the open end of the Audio Cable to the Receiver (usually there is an
audio bus of some sort).
3.
Plug the Audio Cable into the Audio Jack. Do not confuse the Audio Jack
with the Ethernet connector.
4.
Connect the USB cable from the DSP-D300 to the PC.
61