Floor & Ceiling Mounted Units (82000)
20
Zero-Gravity
®
Radiation Protection System Uncrating Instructions
CAUTION! HEAVY EQUIPMENT
Use care when handling the base. The base weighs~ 660 pounds (300
kilograms) and is not intended to be lifted.
6. Find the spring pin in Foam Block 1 from Figure 9. Place the spring pin into the
hole on the far side of the column.
7. Slightly loosen the ratchet straps. Ensure the column spring pin is
not
locked in
the retracted position so it will slide into place. Let the column move up slightly
till the column locking spring pin moves into position. This should occur within 1”
of upward movement. The snubber handle will need to be open to allow for the
upward movement.
8. Once the column pin is in place and holding the column remove the 2 ratchet
straps. Close the snubber handle so it clamps on the column.
9. To remove the base assembly from the wood frame, remove (2) hex head screws
and (2) eye bolts, these should be finger tight and loosen easily. Also remove the
front and back wood frame pieces (Figure 10).
10. Using a 5/16-inch hex key, Located in the Tool Box (I from Figure 1) in the Base
Assembly, lower the leveling pads until the base assembly lifts from the wood
blocks (Figure 11).
