![background image](http://html1.mh-extra.com/html/thyssenkrupp/daf-330/daf-330_operating-manual_1113951036.webp)
O
PERATING
M
ANUAL
7.
M
AINTENANCE
ThyssenKrupp Aufzugswerke GmbH
7.5
Replacing of traction sheave
Disassembly:
•
Switch off power supply, secure car and counterweight
•
Remove traction sheave cover and/or rope fixing beam
•
Remove load from traction sheave by discarding ropes
•
Secure traction sheave with hoist
•
Measure and note down measure of tensioned brake springs
•
Remove load from tensioning springs until traction sheave is free by
unscrewing the screws
•
Unscrew rope fixing beam
•
Unscrew disk on motor shaft and turn disk of motor shaft once
(the side of the disc recess shall be visible)
•
Unscrew screws in outer hole circle of disk and screw them in traction
sheave hub
•
Remove traction sheave from shaft by tightening the screws uniformly
and alternately.
Place a spacer, 2 to 6 mm thick, under disk and shaft end if the take off
distance is insufficient.
Assembly:
•
Clean shaft end and drilled hole of traction sheave; never make any
dimensional changes in featherkey, groove, shaft or drilled holes.
•
Do not grease or oil shaft or drilled hole.
•
Carefully fit new traction sheave to conical shaft end of motor shaft.
•
Bring position of featherkey and groove in line.
•
Slide traction sheave on motor shaft, note position of brake shoes !
•
Screw disk in inner hole circle of motor shaft. The recess side shall be in
line with the traction sheave.
•
Secure screws against unintentional unscrewing by means of Loctite type
241 and tighten them alternately and uniformly clock-wise. This requires
several operations.
•
Check that brake linings and brake disk surface are aligned laterally. In
the case of mismatch dismount brake shoes, re-arrange spacers on
brake shoe bearings and bring brake linings and brake disk centre in line.
(disk thickness = 1 mm)
•
Adjust pressure force of springs, brake shoe stroke 0.3 mm and brake
test switch.
•
Mount traction sheave cover and/or rope fixing beam.
Attention :
if the traction sheave is assembled incorrectly it can work loose.
See to it that screws are tightened and check tightening torque
!
See table 9.1 in annex.
36
Version 02/2009
DAF330