THORLABS M2MS, Operating Manual

Page: 27 / 167

BP209 Series 6 The Graphics User Interface (GUI)
Rev: 8.1, 14-Feb-2022 © 2022 Thorlabs Page 25
6.3 Status Bar
The status bar displays important status information about the Slit Beam Profiler concerning
·
Errors and warnings, see chapter Warnings and Errors .
·
Plot Data Point Status, see section Plots .
·
Instrument settings like taken samples, scan rate and target resolution.
·
Current refresh rate of the application in frames per seconds (fps).
6.4 Save Settings
The actual settings of the GUI including configurations of the graphical displays and the instru-
ment setup are automatically saved when exiting the program. When starting the Beam Soft-
ware again, the most recent settings are automatically loaded.
Exception: Gain and bandwidth are set to "Auto", automatic baseline correction disabled.
Note
The stop state of the previous measurement will be ignored at a new start of the Beam Soft-
ware because it always starts in continuous mode.
140
55