THERMOROSSI CIAO, Manual

Page: 10 / 40

Pg. 10
4.3 MOUNTING THE CASING OF
MODEL 2000
Once the heater had been positioned and the
mounting feet adjusted, proceed to mount the
casing.
Attach the plates A to the left and right side
panels with the supplied screws C. Position the
left and right kickplates D on their respective sides and fix with screws E and F. Tighten the centring screw G in the kickplate with
the smallest hole.
Position the side panels F, previously assembled, on the stove body by matching up the slots G with the tabs H on the base.
Secure the side panels with screws I and screws L.
5 – DESCRIPTIONS OF CONTROLS
5.1 DESCRIPTION OF THE CONTROL PANEL AND BACK PANEL
5.1.1 DESCRIPTION OF THE CONTROL PANEL
There are two main control pushbuttons marked with the symbol of the flame (1) and with the ventilation symbol (2) respectively.
The flame button (1) sets the heater power, there are five possible power levels displayed by the five leds progressively coming on
in sequence (10). The shutdown cycle appears on the display when all the five power leds (10) are off. The button (2) controls the
ventilation of the heater. It is activated when the heater reaches a temperature equal to or greater than 42 °C. Ventilation can be
regulated up to six speed levels (9). When the heater is on the ventilation cannot be switched off.
1) Heater on/off and power regulation button: press this
button to start the ignition cycle of the appliance Star/On; during
this stage the third red LED will blink. Press repeatedly to pass
on to the various power settings from 1 to 5 (10) up until the
shutting down stage; during this stage the third LED blinks for 5
seconds, after which the word OFF appears on the control
panel and all the LEDs switch off.
2) Ventilation setting button: Press this button to set the
desired ventilation level; select from up to a maximum of six
possible speeds that correspond to the number of LEDs (9) lit
up.
F
F
G
G
H
H
I
I
L
L
M
M
D
E
F
A
C
B
B
G