MAX/Wall
®
Technical Wall System
55
Section 4 – Installing Supporting Furniture and Casework
4.13 520H Series Drawer Units
to a Table
Tools Required:
Phillips head screwdriver with No. 2 and 3 tips
3/4" and 7/16" Combination wrench or socket set
with 7/16" socket
Hardware Included:
Hardware Bag No. 684435 consisting of:
Upper front clamps
Upper rear brackets
1/4-20 x 2" carriage bolts
1/4-20 x 3/4" carriage bolts
1/4-20 Hex nuts
Refer to Figure 4-31
1. Remove drawer from the suspended frame.
2. Insert the 1/4-20 x 3/4" carriage bolts into
the rear brackets of the suspended drawer
frame, apply the 1/4-20 hex nuts and hand
tighten.
3. Slide the rear brackets of the suspended
drawer frame onto the rear support channel or
the ”C” channel of the work surface frame.
See the exploded view.
Refer to Figure 4-32
4. Use the upper front brackets as shown to attach
the front of the drawer frame to the front ”C”
channel of the work surface frame. Tighten the
1/4-20 x 2" carriage bolts.
5. Tighten the carriage bolts in the upper rear
brackets until the suspended drawer frame
hangs square to the frame.
6. Insert the drawer into the frame assembly.
Figure 4-31 Attaching Rear Top Bracket
1/4-20 x 3/4" Carriage Bolt
2"
Suspended
Drawer
.063
Rear
Support
Channel
Rear Bracket
Suspended Drawer
Attach a third top front
clamp at center location
for 36–48" wide drawers
Upper Front
Frame Member
Clamp
Suspended Drawer
3/16"
Attaching front top clamp to front frame
Attaching front top clamp to front
frame and Accent (J-Line) cabinet
Upper Front
Frame Member
Clamp
Suspended Drawer
1/2"
Figure 4-32 Attaching Front Top Clamp
Summary of Contents for FISHER HAMILTON MAX/WALL
Page 1: ......
Page 58: ...MAX Wall Technical Wall System 58...
