MAX/Wall
®
Technical Wall System
43
Section 4 – Installing Supporting Furniture and Casework
4.5 Corner Table Support for
Cantilever Work Surface or
Structural Table
(cont.)
3. Loosen the side frame from the corner post just
enough to allow it to swing a minimum of 1" side-
ways from the corner of the work surface as
shown in Figure 4-12.
4. Place the corner support under the table frame
with the hooks pointing towards the side frame.
5. Lift the frame and the corner support. Swing the
side support structure back to the place of origin
and insert the hooks of the corner support into
the slots in the frame.
Note:
Front leveler of the side frame may have to be
screwed into the lower structure for easier insertion
of the hooks. If so, return the leveler to the correct
height after the hooks are engaged.
6. Strike the work surface with a rubber mallet to
insure the corner support is secure.
7. Re-tighten the side frame to the corner connector.
Figure 4-12 Attaching Corner Table Support
Cantilever Frame
Wall Frame
Wall Frame
Corner Support
Swing Frame
Out 1"
Summary of Contents for FISHER HAMILTON MAX/WALL
Page 1: ......
Page 58: ...MAX Wall Technical Wall System 58...