MAX/Wall
®
Technical Wall System
30
3.13 Ceiling Facing Inserts,
Steel and Fabric
Tools Required:
Phillips screwdriver
Jigsaw with metal cutting blade
Hardware Included:
4 /8 x 1/2" PPHSMS
4 Retainer clips
Procedure:
1. Cut the top edge of the panel to the required
height as necessary.
2. Fasten the retainer clips to the top surface of the
top rail of the wall frame.
3. Insert the top of the panel into the opening of the
ceiling channel and slide the lower panel flange
in under the retainer clips. See Figure 3-21.
Section 3 – Installing Wall Frames
3.12 Ceiling Facing Inserts
Tools Required:
Phillips screwdriver
Jigsaw with metal cutting blade
Hardware Included:
4 /8 x 1/2" PPHSMS
4 Retainer clips
Procedure:
1. Cut the top edge of the panel to the required
height as necessary.
2. To apply the reinforcing angle to the back side,
at the top of the panel; clean the location with
mineral spirits and allow to dry before applica-
tion. Peel release film from foam tape and attach
to the panel.
3. Fasten the retainer clips to the top surface of the
top rail of the wall frame.
4. Insert the top of the panel into the opening of the
ceiling channel and slide the lower panel flange
in under the retainer clips. See Figure 3-21.
Figure 3-21 Ceiling Facing Inserts, Fabric
Ceiling
Extensions
No. 10 x 5/8"
PPHSMS
Ceiling Channel
Ceiling
Facing
Insert
Ceiling
Facing
Insert
Top Frame Rail
Reinforcing Angle
Reinforcing
Angle
Foam Tape
Top Frame Rail
Retainer Clips
Summary of Contents for FISHER HAMILTON MAX/WALL
Page 1: ......
Page 58: ...MAX Wall Technical Wall System 58...
