MAX/Wall
®
Technical Wall System
47
4.9 Sloping Adjustable Shelf
to Wall Frame
Tools Required:
Phillips head screwdriver with No. 2 and 3 tips
Refer to Figure 4-17.
1. Attach the right hand and left hand
shelf brackets to the shelf using
No. 10-24 x 1/2" PPHMS.
2. Attach the shelf lip to the front
edge of the shelf using No.
10 x 5/8" PPHSMS.
3. Insert the hooks on the shelf
brackets into the slots in the
risers of the wall frame. Shelf
height is adjustable by inserting
hooks into different slots. The
slots are spaced at 1" increments
4. Lock the shelf bracket assemblies to
the risers by screwing No. 8 x 5/8"
PPHSMS through the bracket and into the
slot. Push the shelf brackets downward to
fully engage the hooks into the slots.
Refer to Figure 4-18.
5. The shelf angle may be adjusted by pulling
the spring-loaded pins inward to disengage
the pin from the shelf bracket. Tilt the shelf
to the desired angle and release the spring-
loaded pin. Be sure the pins are fully
engaged in the shelf bracket holes before
any load is paced on the shelf.
6. The spring-loaded pins may be temporarily
disengaged by pulling the pin inward and
then rotating it counter-clockwise until it is
held out. This allows the tilting adjustment
of the shelf without having to hold both pins
at the same time. To re-engage the pin,
rotate clockwise to release and make sure
the pin is fully engaged in the shelf bracket
holes.
Figure 4-18 Attaching Sloping Shelf
Figure 4-17 Assembling Sloping Shelf
Section 4 – Installing Supporting Furniture and Casework
Shelf
Riser
Extrusion
Shelf
Bracket
10-24 x 1/2"
PPHMS
Shelf Lip
10 x 5/8"
PPHSMS
8 x 5/8" PPHSMS
End
Shelf
Lip
Spring-
Loaded
Pin
Shelf
Riser
Extrusion
Tilt
Shelf
Spring-Loaded Pin
Summary of Contents for FISHER HAMILTON MAX/WALL
Page 1: ......
Page 58: ...MAX Wall Technical Wall System 58...
