Thermo King T-1090 SPECTRUM, Operator'S Manual

Page: 36 / 112

36 TK 56704-1-OP-EN
IIm mp po orrtta an ntt:: If the setpoint is changed using the + or - keys, the change must
be confirmed or rejected by pressing the YES or NO soft key
within 10 seconds of changing the setpoint.
• If the YES key is pressed, the setpoint change made with the + or - key is
accepted, the setpoint changes, and the display returns to the Standard
Display.
• If the NO key is pressed, the setpoint change made with the + or - key is
not accepted, the setpoint is not changed, and the display returns to the
Standard Display.
• If either the YES or NO key is not pressed within 10 seconds of making a
change with the + or - key, the setpoint is not changed, and the display
returns to the Setpoint Display. The display briefly shows [SETPOINT
NOT CHANGED] and Alarm Code 127 Setpoint Not Entered is set, to
indicate that a setpoint change was started but not completed.
Figure 32. Standard Display, New Setpoint
Starting the Diesel Engine
C CA AU UT TIIO ON N
R Riisskk o off IIn njju urry y!!
The engine may start automatically any time the unit is turned on.
N NO OT TIIC CE E
E Eq qu uiip pm me en ntt D Da am ma ag ge e!!
Never use starting fluid. Damage to the engine can occur.
Diesel engine preheats and starts are automatic in both Continuous Mode
and CYCLE-SENTRY Mode. The engine will preheat and start as required
when the unit is turned on. The engine preheat and start will be delayed in
CYCLE-SENTRY mode if there is no current need for the engine to run. If any
O Op pe erra attiin ng g IIn nssttrru uccttiio on nss ffo orr P Prre em miiu um m H HM MII C Co on nttrro oll P Pa an ne ell