Thermia Calibra Cool, Installation Manual

Page: 16 / 44

5.2 General information for brine connection
The quick couplings included are tool-free and pushed in place. The coupling locks automatically. Before mounting, check that there are
no sharp edges or irregularities on the pipe that could damage the rubber sealing in the couplings and cause leakage. The coupling can
be rotated after mounting on pipes.
32 mm
32 mm
Press the coupling on to the pipe and make sure it reaches the 32 mm mark.
To disassemble: (if required)
1. Push the plastic ring inwards
2. Pull the pieces apart
1 2
Insulate the brine pipe and prepare with the insulation tape before installing the pipe in the heat pump. Loosen the tape from the pro-
tective film in partly, and place it behind the clutch when mounted on the pipe. This makes it easier to complete the insulation when the
pipe is in place in the heat pump.
In order to access the brine connections, the heat pump front and the metal plate to the electrical cabinet must be
removed.
Installation Guide Calibra Cool
BWCC01IG0102 Thermia AB
16