Thermia Calibra Cool, Installation Manual

Page: 30 / 44

8.1.10 Activate manual test
Ensure that the main circuit breaker is on. The display will start up within 1 minute.
1. Press on the Start screen to open the Menu screen.
2. Press on Settings
.
3. Press to go to the menu page for Manual test.
4. Press on the text Manual test.
5. Press
to activate manual test.
6. Select test case on the various menu pages.
During MANUAL TEST, this symbol is shown on all screens:
Note:
▪
Start the circulation pump, listen for air. Run the reversing valve to hot water, listen or air. If necessary, bleed.
▪
Start the brine pump, listen for air. If necessary, bleed.
▪
If necessary, the compressor and the internal immersion heater can also be run in manual testing. Additional test cases may apply if
external devices are installed and activated.
▪
After completion of the test, close "manual test".
Parameter Meaning
Circulation pump 0 = stop circulation pump 1 = start circulation pump
Brine pump (or 2 way valve, WW version) 0 = stop brine pump 1 = start brine pump
Compressor 0 = compressor stopped Set compressor gear
Internal Immersion heater Three steps: 1, 2 and 3.
Reversing valve 0 = Heating 1= Hot water
Reversing valve cooling 0 = Heating 1= Cooling
8.1.11 Selecting operating mode
Set the heat pump to the desired operating mode in the menu:
1. Press on the Start screen to open the Menu screen.
2. Press
. A new window opens.
3. Press the appropriate symbol for the desired operating mode.
If the compressor has been in operation for the past 20 minutes, so-called restriction time may occur temporarily preventing the
heat pump from starting.
Installation Guide Calibra Cool
BWCC01IG0102 Thermia AB
30