8. Installing the Printer’s Optional Accessories
The Optional Internal Rewind or Cutter can be easily installed and configured in the field using only a
number 2 Phillips screwdriver. This section will provide a component list and installation instructions
for both of these optional accessories.
CAUTION!
Make sure that the Printer’s power switch is in the “O” or “Off”
position before proceeding with the installation.
CAUTION!
Unplug the power cord from the Printer before performing any service
on it. Failure to do so could result in personal injury or damage to the
Printer!
THARO H-Series Internal Rewind Module Components
1.
2.
3.
Internal Rewind Module
U-Shaped Metal Clip
Screws (M3X4.5) Qty. 4
NOTICE!
The Internal Rewind must be used with the Stripper Sensor. Make sure
the Stripper Sensor is turned on in the Printer’s Setup Mode before using
the Internal Rewind.
NOTICE!
When the diameter of the wound label liner reaches about 110mm (4.33”)
the liner will touch the maximum liner switch and the Printer will stop
printing. The Printer will not resume printing until the used liner is
removed.
- 19 -
