Label Installation
1. Open the Printer’s top cover.
2. Slide the roll of label stock onto the
Label Roll Bar all the way back to the
Printer’s inner wall.
3. Slide the Label Width Guide in until it
rests against the label stock. Avoid
pushing the guide in too far or you
will damage the edge of the label
stock.
4. Pull the Printhead Lever out and
rotate it up and to the right
(counterclockwise) to open the
Thermal Printhead.
5. Slide the Outside Label Feed Guide
to its outermost position and rotate
it upward.
6. Feed the label stock through the two
Label Feed Rods to the Tear-Off Bar.
Make sure the label stock is fed
under the Moveable Sensor.
- 17 -
