22 G-TECH/Pro SS/RR Fanatic Manual
Note:
Your vehicle must be moving at speed grater than 5 mph for gate to be accepted. Adding gates while stopped or
moving with less than 5 mph will be ignored.
When you finish the first lap on track (cross the
START/FINISH line), G-TECH will switch from “Recording
map…” into “RACING” mode. You will also see the
message that informs you on 1
st
lap time as shown here
After few seconds message will clear, leaving just the
RACING screen as shown here.
Note:
If you just want to record map without driving the whole session, you can stop RR Session recording after the 1st
lap. In that case skip the following set of instructions and go straight to next set on stopping the RR Session recording.
G-TECH will use recorded data to create map for the track you were driving.
If you added segment gates during the map recording,
crossing over one of these gates will bring the segment
time message on screen as shown here
When you finish the 2
nd
lap on track, G-TECH will bring
up the “Thumb” screen to inform you on time you
gained or lost in the lap as shown here
If you added segment gates during the map recording,
starting from 2
nd
lap, crossing over one of these gates
will bring the “Thumb” screen with the amount of time
you gained or lost. as shown here
