20 G-TECH/Pro SS/RR Fanatic Manual
6.2.2
Driving on new location
Make sure G-TECH is mounted properly, powered on, in
RR mode, GPS has a valid signal and Main Screen is
displayed
Press
REC
button to initiate
RR Session recording
G-TECH will prepare itself for RR Session which may take
few seconds
When G-TECH finishes preparing for RR Session you will
be presented with this info screen
Now you need to tell G-TECH where the START/FINISH
line is. To do that, you need to press
REC
button when
your car is on the START/FINISH line. There are two ways
to do that:
•
drive your car to the START/FINISH line, stop it there,
press
REC
button and hit the accelerator.
•
or drive down the track, and without stopping at
START/FINISH line, press
REC
button at the exact
moment that you pass over the START/FINISH line.
This way you will set the first gate on this map, the
START/FINISH gate
Note:
When setting the START/FINISH gate, make sure that you approach the START/FINISH line straight forward. Also,
do not move your vehicle back and forth around START/FINISH line trying to position your car right on to it. Instead, just
drive straight forward to START/FINISH line and stop at it.
If you approach the START/FINISH line at an angle, the START/FINISH gate that you are setting will also be angled in
respect to the track. Moving your car back and forth at the START/FINISH line can cause your START/FINISH gate to be
oriented in wrong direction. In that case, G-TECH will not be able to detect when you cross START/FINISH line.
