Document 57.4400.7200 - 1
st
Edition 03/2005
INDEX
2
32
TELELIFT 3713 Elite - 4017 - 4514
TECHNICAL SPECIFICATIONS
DISPLAY
FUNCTION
0
The LED bar indicates the type of machine in use:
2 LEDs on - T3713 Elite/T4017/T4514
Press
or
to select the machine to calibrate.
If you are doing the first calibration, press
to reset the system and load the default
parameters of the selected machine.
Press
to proceed to the next point (1).
1
Lower the outriggers, fully close the boom and hold it slightly above the horizontal with
respect to the ground.
DON’T
lift loads.
Press
to confirm the
EMPTY
calibration of the machine.
Press
to proceed to the next point (2).
2
Place a load on the forks with a weight corresponding to the table on next page - in
relation to the model -, extend the boom while holding it horizontal till reaching the
overturning limit (ex. Telelift 3713 Elite with outriggers down 1000 kg at 7.50 m referred
to the front part of the wheels).
Press
to confirm the
LOADED
calibration of the machine and check that the alarm
triggers.
Hold the load on the forks, raise the outriggers and extend the boom up to 5.35 calculated
from the front part of the wheels to the centre of the load on the fork. Hold this position
till the end of the procedure explained in point 3.
Press
to proceed to the next point (3).
3
Press
a few times so that only the green LED's remain lit (the first 4 LED's on the
display), then press
so that the first red LED lights up (the last one on the display).
Press
to proceed to the next point (4).
4
Calibration of the machine when working with the NACELLE.
Move to a limit point of the load table with stabilizers down.
Press
or
to decrease/increase the operational % until the first red LED of the
bar lights up. It is recommended to move the bar to the green/yellow zone and to increase
later on.
Press
to proceed to the next point: the system goes automatically to point A. If the
calibration is okay, go on pressing
to proceed to point F.
Summary of Contents for TELELIFT 3713 Elite
Page 4: ...Courtesy of Crane Market...
